Pool Pump Replacement Cost
A new pool pump installed runs $900–$2,600 depending on type and size. Since most replacements must now be variable-speed, the upfront cost is higher than the old single-speed units it replaces — and the electricity saving typically pays that back within a few years.
Typical national range
$900–$2,600
Standard residential variable-speed pump through a high-performance unit, installed, including basic plumbing reconnection.
What this project needs measured
Measurements are only requested when they change the price of the work you selected. Everything below is collected inside the estimator — you can enter dimensions you already know or measure as you go.
Required
No measurement required
This project is diagnosed from symptoms and equipment details rather than dimensions.
Cost by pump type
| Type | Installed |
|---|---|
| Variable-speed, standard residential | $900–$1,900 |
| Variable-speed, high performance | $1,500–$2,600 |
| Single-speed (where still permitted) | $500–$900 |
| Motor only, existing wet end | $450–$1,000 |
What can add to the installed cost
- Plumbing reconfiguration. $200–$800, if the new pump’s footprint does not match the old one.
- Electrical work. $200–$900, where the circuit or bonding needs updating for the new unit.
- Pad or base repair. $100–$400, if the mounting pad has deteriorated.
- Removal and disposal. Usually included, but confirm.
The running-cost side of the equation
Unlike most equipment purchases, a pump replacement is not just an installed cost — it changes your electricity bill, usually substantially, because variable-speed pumps can run longer at much lower power draw than a single-speed unit.
Treat the installed price as half the comparison. The other half is what you are currently paying to run the old pump, which your installer or utility can help estimate.
How to read a PoolSavr estimate
- Step 1
Instant estimate
Based on your project selections and general pricing assumptions. Useful for deciding whether a project is realistic.
- Step 2
Measured estimate
Uses your pool, spa, or deck dimensions to price the work against the areas actually being resurfaced, tiled, or replaced.
- Step 3
Contractor proposal
Prepared by a licensed professional after inspecting the site. This is the only number that becomes a contract.
PoolSavr is an estimating and matching platform. We do not perform pool work ourselves — licensed local professionals do. Contractors pay PoolSavr for qualified project leads, which is how the estimating tools stay free for homeowners. A PoolSavr estimate is a planning range, never a guaranteed quote — read thefull estimate disclaimer.
Frequently asked questions
- How much does it cost to replace a pool pump?
- Typically $900–$1,900 installed for a standard variable-speed pump, and $1,500–$2,600 for a high-performance unit. Plumbing and electrical work can add several hundred dollars each.
- Are utility rebates available?
- Often, yes — many electric utilities offer rebates for variable-speed pool pumps, sometimes several hundred dollars. Check with your utility and ask your installer.
- Is a variable-speed pump worth the higher cost?
- For most households, yes. The electricity saving from running longer at low speed typically pays back the price difference within a few years, and it is now the default option for most replacement sizes regardless.
Ready to see what your project costs?
Start with the work you are considering. You will get a preliminary range before anyone asks for your phone number, and you decide whether to request a contractor review at the end.